INSTALLATION
20
■
■
Remove slack from the cord by moving
the cord tensioner away from the end
plate it is looped around.
■
➤
If the tensioner must be moved more
than one-third of the headrail width
away from its end plate to remove
slack, re-tie the knot and trim the
excess cord.
■
➤
Do not put tension on the cord at this
time. Just remove the slack.
■
■
Adjust the moving rail to vertical, if necessary. Work from the front side of the shade.
■
➤
Locate the Phillips screws on the moving rail bracket.
■
➤
To adjust the bottom end of the moving rail to the right, loosen the right screw one-half
turn, then tighten the left screw one-half turn. Repeat until the rail is properly aligned.
■
➤
To adjust the bottom end of the moving rail to the left, loosen the left screw one-half
turn, then tighten the right screw one-half turn. Repeat until the rail is properly aligned.
IMPORTANT:
After making the adjustments, check to be sure both screws are tight on the
moving rail bracket.
Left Stack
= Tighten
= Loosen
Right Stack
Summary of Contents for Douette PowerView
Page 43: ......
