Hubner AMP 41, Operating And Assembly Instructions Manual

Page: 88 / 106

88 AMP(H)41_MANUAL-en_R11 - 2019-03-28
Absolute Encoder AMP(H) 41
13 Checklist
We recommend that you print out and work through the checklist for commissioning, when
replacing the measuring system and when changing the parameterization of a previously
accepted system, sign it and store it as part of the overall system documentation.
Documentation reason Date Edited Checked
Sub-item To note Can be found under Yes
Present user manual has been read and understood.
Document no.:
AMP(H)41_MANUAL-en_R11

Check that the
measuring system
can be used for the
preset automation
task on the basis of
the specified safety
requirements

Intended use

Compliance with all technical data
Chapter 2.3
Intended use
on page 15
Chapter 14
Technical Data
on page 89

Fulfillment of the
installation
requirements defined
in the user manual
Safe mechanical fixing of the measuring
system and safe positive connection of the
driving shaft with the measuring system
Chapter 4
Assembly
on page 20

Requirement for the
power supply
The power supply used must meet the
requirements of
SELV/PELV
(IEC 60364-4-41:2005)
Chapter 5.3.1
Supply voltage
on page 28

Correct PROFIBUS
installation
Observance of the international standards
valid for PROFIBUS / PROFIsafe or the
directives specified by the PROFIBUS User
Organization
Chapter 5
Installation / Preparation for
Commissioning
on page 26
Chapter 6
PROFIBUS / PROFIsafe –
Commissioning
on page 33

System test after
commissioning and
parameter changes During commissioning and after each
parameter change all affected safety
functions must be checked.
Chapter 6.7
Parameterization
on page 46

Preset Adjustment
Function
The preset adjustment function may only be
executed when the affected axis is
stationary.
It must be ensured that the preset
adjustment function cannot be inadvertently
triggered.
After execution of the preset adjustment
function the new position must be checked
before restarting.
Chapter 10
Preset Adjustment Function
on page 80

Device replacement
It must be ensured that the new device
corresponds to the replaced device.
All affected safety functions must be
checked.
Chapter 6.7
Parameterization
on page 46
Chapter 12
Replacing the Measuring
System
on page 87
