Hubner AMP 41, Operating And Assembly Instructions Manual

Page: 85 / 106

Absolute Encoder AMP(H) 41
AMP(H)41_MANUAL-en_R11 - 2019-03-28 85
11.2.1.1 Station status 1
Standard diagnosis byte 1
Bit 7 Master_Lock
Slave has been parameterized from another master (bit is
set by the master)
Bit 6 Parameter_Fault
The parameter telegram last sent has been rejected by the
slave
Bit 5 Invalid_Slave_Response
Is set by the master, if the slave does not respond.
Bit 4 Not_Supported
Slave does not support the requested functions.
Bit 3 Ext_Diag
Bit = 1 means an extended diagnosis report from the slave
is waiting.
Bit 2 Slave_Cfg_Chk_Fault
The configuration identifier(s) sent from the master has
(have) been rejected by the slave.
Bit 1 Station_Not_Ready
Slave is not ready to exchange cyclical data.
Bit 0 Station_Non_Existent
The slave has been configured, but is not available on the
bus.
11.2.1.2 Station status 2
Standard diagnosis byte 2
Bit 7 Deactivated Slave was removed from the poll list from the master.
Bit 6 Reserved
Bit 5 Sync_Mode Is set by the slave after receipt of the SYNC command.
Bit 4 Freeze_Mode
Is set by the slave after receipt of the FREEZE command.
Bit 3 WD_On The response monitoring of the slave is activated.
Bit 2 Slave_Status
Always set for slaves
Bit 1 Stat_Diag Statistic diagnosis
Bit 0 Prm_Req
The slave sets this bit if it has to be reparameterized and
reconfigured.
11.2.1.3 Station status 3
Standard diagnosis byte 3
Bit 7 Ext_Diag_Overflow
Overflow for extended diagnosis
Bit 6-0 Reserved
11.2.1.4 Master address
Standard diagnosis byte 4
The slave enters the station address of the master into this byte, after the master has sent a
valid parameterization telegram. To ensure correct function on the PROFIBUS it is imperative
that, in the case of simultaneous access of several masters, their configuration and
parameterization information exactly matches.