Huber KISS 1 Series, Operation Manual

Page: 41 / 56

Interfaces and data communication
Chapter 6 OPERATION MANUAL
V1.2.0en/11.12.20//0.3.1
KISS Immersion Circulator
41
6 Interfaces and data communication
Connecting to the interfaces at the temperature control unit during operation
DAMAGE TO THE INTERFACES

When devices in operation are connected with interfaces of the temperature control unit,
interfaces may get damaged.

Before connecting, ensure the temperature control unit and the device to be connected are
turned off.
The specifications of the interface used are not being met.
PROPERTY DAMAGE

Only connect components that meet the specifications of the interface used.
6.1 Controller interfaces
6.1.1 USB-2.0 interface
The interfaces used must meet the specifications of the generally accepted standards. The neces-
sary drivers for the interface can be found at:
www.ftdichip.com/Drivers/VCP.htm
6.1.1.1 USB-2.0 interface, device
USB-2.0 connection (for Mini-B connector) for communicating with a computer.
6.1.2 RS232 jack
A PC, a SPS or a Process Control System (PCS) can be connected to this jack for remote control of the
controller electronics. Before plugging in the cable, check the settings in the “Interfaces” category
and adjust if necessary.
The interfaces used must meet the specifications of the generally accepted standards.
Pin Signal Description
2 RxD Receive Data
3 TxD Transmit Data
5 GND Signal GND
Standard interfaces on
the top side of “KISS”
Pin assignment (front
view)
Pin assignment