Shenzhen Hpmont Technology Co., Ltd.
Chapter 6 Function Introduction
HD3L Series Controller User Manual
―
47
―
Ref. Code
Function Description
Setting Range [Default]
F00.06 M-key
function
0,1 [0]
0:
Unused.
1: UP / DN switch. Switch the UP / DN of motor with
key on the keypad.
F00.07
Speed setting of keypad
0.000 - F00.02 [1.500m/s]
F00.05 = 0, it sets the objective speed at running.
F00.08 Run
direction
0,1 [0]
0: The same as run command.
1: Opposite to run command.
6.2.2
F01: Protection of Parameters
Ref. Code
Function Description
Setting Range [Default]
F01.00
User’s password
00000 - 65535 [0]
XXXXX: To enable the password protection function, set any non-zero number as the password.
•
Once the password is set, and detect that there is no press on the keypad within 5 minutes, the user’s
password will be valid.
•
To change the parameters, input correct password. Otherwise can not change any parameter via
keypad, but only check.
00000: The factory setting and no user’s password.
•
If user unlocks the password, it means clearing the user’s password.
•
To unlock, change and clear the user’s password, refer to section 5.2.3.
F01.01 Menu
mode
0,1 [0]
0: Full menu mode. All parameters can be displayed.
1: Checking menu mode. Only parameters different from factory setting can be displayed.
F01.02
Function code parameter initialization
0 - 3 [0]
0: No operation. HD3L is in regular parameter read / write status.
•
Whether can change the parameter depends on the user’s password status and the actual running
conditions of HD3L.
1: Restore to factory settings.
•
Except Group F01, F07.00 - F07.14, F15.00, F17.11 - F17.27, Group F18 and Group Y.
•
Steps:
If set F01.02 = 1, press
to ensure and the parameters are restored to factory settings. The
keypad dispalys “rESEt”. Then the keypad will display parameters in stop status after finish restoring to
factory setting.
2: Parameter download.
•
Except Group F01, F17.11 - F17.27, Group F18 and Group Y.
•
Motor parameters, encoder parameters and magnetic pole angle etc. will be downloaded.
•
Record the original parameters such as motor parameters, encoder parameters and magnetic pole
angle etc. or restart parameter auto-tuning.
3: Clear fault information. The fault history of F17.11 - F17.27 will be cleared.
F01.03
Keypad EEPROM parameter initialization
0,1 [0]
0: No operation. HD3L is in regular parameter read / write status.
1: Upload the current function code settings to the keypad EEPROM parameter.
Note: Group F01, F17.11 - F17.27, Group F18 and Group Y do not upload.
6