HPE FlexNetwork 10500 SERIES, Configuration Manual

Page: 350 / 407

339
Figure 97 CWMP message interaction procedure
Configuration task list
To use CWMP, you must enable CWMP from the CLI. You can then configure ACS and CPE
attributes from the CPE's CLI, the DHCP server, or the ACS.
For an attribute, the CLI- and ACS-assigned values have higher priority than the DHCP-assigned
value. The CLI- and ACS-assigned values overwrite each other, whichever is assigned later.
This document only describes configuring ACS and CPE attributes from the CLI and DHCP server.
For more information about configuring and using the ACS, see ACS documentation.
To configure CWMP, perform the following tasks:
Tasks at a glance Remarks
(Required.) Enabling CWMP from the CLI
To use CWMP, you must enable CWMP from the
CLI.
Configuring ACS attributes :
•
(Required.) Configuring the preferred ACS
attributes

Assigning ACS attributes from the DHCP server

Configuring the preferred ACS attributes from
the CLI
•
(Optional.) Configuring the default ACS attributes
from the CLI
The preferred ACS attributes are configurable
from the CPE's CLI, DHCP server, and ACS.
The default ACS attributes are configurable only
from the CLI.
CPE
(1) Open TCP connection
(2) SSL initiation
(4) HTTP response ( Inform response )
(3) HTTP post ( Inform )
(6) HTTP response ( GetParameterValues request)
(5) HTTP post (empty)
(8) HTTP response ( SetParameterValues request)
(7) HTTP post ( GetParameterValues response)
(11) Close connection
(10) HTTP response (empty)
(9) HTTP post ( SetParameterValues response)