HPE FlexNetwork 10500 SERIES, Configuration Manual

Page: 12 / 407

1
Using ping, tracert, and system
debugging
This chapter covers ping, tracert, and information about debugging the system.
Ping
Use the ping utility to determine if an address is reachable.
Ping sends ICMP echo requests (ECHO-REQUEST) to the destination device. Upon receiving the
requests, the destination device responds with ICMP echo replies (ECHO-REPLY) to the source
device. The source device outputs statistics about the ping operation, including the number of
packets sent, number of echo replies received, and the round-trip time. You can measure the
network performance by analyzing these statistics.
Using a ping command to test network connectivity
Execute ping commands in any view.
Task Command
Determine if an address in an IP network is
reachable.
When you configure the ping command for a low-speed
network, set a larger value for the timeout timer (indicated by
the
-t keyword in the command).
•
For IPv4 networks:
ping [ ip ] [ -a source-ip | -c count | -f | - h ttl | -i
interface-type interface-number | -m interval | -n | -p pad |
-q | -r | -s packet-size | -t timeout | -tos tos | -v |
-vpn-instance vpn-instance-name ] * host
•
For IPv6 networks:
ping ipv6 [ -a source-ipv6 | -c count | -i interface-type
interface-number | -m interval | -q | -s packet-size | -t
timeout | -v | -tc traffic-class | -vpn-instance
vpn-instance-name ] * host
For more information about the ping mpls command, see MPLS Command Reference .
Ping example
Network requirements
As shown in Figure 1 , determine if Device A and Device C can reach each other. If they can reach
each other, get detailed information about routes from Device A to Device C.