HPE FlexNetwork 10500 SERIES, Configuration Manual

Page: 343 / 407

332
1. Create a network named Network .
2. Create subnets:
# Create a subnet named subnet-1 and assign network address range 10.10.1.0/24 to the
subnet. (Details not shown.)
# Create a subnet named subnet-2 , and assign network address range 10.1.1.0/24 to the
subnet. (Details not shown.)
In this example, VM 1 and VM 2 obtain IP addresses from the DHCP server. You must enable
DHCP for the subnets.
3. Create a router named router . Bind a port on the router with subnet subnet-1 and then bind
another port with subnet subnet-2 . (Details not shown.)
4. Create VMs:
# Create VM 1 and VM 2 on Compute node 1 and Compute node 2, respectively. (Details not
shown.)
In this example, VM 1 and VM 2 obtain IP addresses 10.10.1.3/24 and 10.1.1.3/24 from the
DHCP server, respectively.
Verifying the configuration
Verifying the collected topology of the underlay network
# Display VCF fabric topology information on Device A.
[DeviceA] display vcf-fabric topology
Topology Information
----------------------------------------------------------------------------------
* indicates the master spine role among all spines
SpineIP Interface Link LeafIP Status
*10.11.113.51 GigabitEthernet1/0/1 Up 10.11.113.52 Deploying
GigabitEthernet1/0/2 Down -- --
GigabitEthernet1/0/3 Down -- --
GigabitEthernet1/0/4 Down -- --
GigabitEthernet1/0/5 Up 10.11.113.53 Deploying
GigabitEthernet1/0/6 Down -- --
GigabitEthernet1/0/7 Down -- --
GigabitEthernet1/0/8 Down -- --
Verifying the automated configuration for the underlay network
# Display information about automated underlay network provisioning on Device A.
[DeviceA] display vcf-fabric underlay autoconfigure
success command:
#
system
clock timezone newyork add 08:00:00
#
system
lldp global enable
#
system
stp global enable
#
system