HPE FlexNetwork 10500 SERIES, Configuration Manual

Page: 39 / 407

28
•
If the threshold is violated, the state of the entry is set to over-threshold. Otherwise, the state of
the entry is set to below-threshold.
If the action is trap-only for a reaction entry, a trap message is sent to the NMS when the state of the
entry changes.
Configuration procedure
Before you configure threshold monitoring, configure the destination address of the trap messages
by using the
snmp-agent target-host command. For more information about the command, see
Network Management and Monitoring Command Reference .
To configure threshold monitoring:
Step Command Remarks
1. Enter system view. system-view
N/A
2. Create an NQA
operation and
enter NQA
operation view.
nqa entry admin-name operation-tag
By default, no NQA operations
exist.
3. Enter NQA
operation view.
type { dhcp | dlsw | dns | ftp | http |
icmp-echo | icmp-jitter | snmp | tcp |
udp-echo | udp-jitter | udp-tracert | voice }
The threshold monitoring feature
is not available for the path jitter
operation.
4. Enable sending
traps to the NMS
when specific
conditions are
met.
reaction trap
{
path-change
|
probe-failure
consecutive-probe-failures | test-complete |
test-failure [ accumulate-probe-failures ] }
By default, no traps are sent to
the NMS.
The ICMP jitter, UDP jitter, and
voice operations support only
the
test-complete keyword.
The following parameters are not
available for the UDP tracert
operation:
•
The probe-failure
consecutive-probe-failures
option .
•
The
accumulate-probe-failures
argument.