HPE FlexNetwork 10500 SERIES, Configuration Manual

Page: 87 / 407

76
Configuring NTP
Synchronize your device with a trusted time source by using the Network Time Protocol (NTP) or
changing the system time before you run it on a live network. Various tasks, including network
management, charging, auditing, and distributed computing depend on an accurate system time
setting, because the timestamps of system messages and logs use the system time.
Overview
NTP is typically used in large networks to dynamically synchronize time among network devices. It
guarantees higher clock accuracy than manual system clock setting. In a small network that does not
require high clock accuracy, you can keep time synchronized among devices by changing their
system clocks one by one.
NTP runs over UDP and uses UDP port 123.
NOTE:
NTP is supported only on the following Layer 3 interfaces:
•
Layer 3 Ethernet interfaces.
•
Layer 3 Ethernet subinterfaces.
•
Layer 3 aggregate interfaces.
•
Layer 3 aggregate subinterfaces.
•
VLAN interfaces, and tunnel interfaces.
How NTP works
Figure 32 shows how NTP synchronizes the system time between two devices (Device A and Device
B, in this example). Assume that:
•
Prior to the time synchronization, the time is set to 10:00:00 am for Device A and 11:00:00 am
for Device B.
•
Device B is used as the NTP server. Device A is to be synchronized to Device B.
•
It takes 1 second for an NTP message to travel from Device A to Device B, and from Device B to
Device A.
•
It takes 1 second for Device B to process the NTP message.