HPE FlexNetwork 10500 SERIES, Configuration Manual

Page: 48 / 407

37
Step Command Remarks
7. (Optional.) Specify the
source IP address for the
probe packets.
•
IPv4 address:
source ip ip-address
•
IPv6 address:
source ipv6
ipv6-address
By default, the packets take the primary IP
address of the output interface as their
source IP address.
The source IP address must be the IP
address of a local interface, and the
interface must be up. Otherwise, no probe
packets can be sent out.
8. (Optional.) Configure the
expected data.
expect data expression
[
offset
number ]
By default, no expected data is configured.
If you want to configure this command,
make sure the
data-fill command is
already executed.
Configuring the HTTP template
A feature that uses the HTTP template performs the HTTP operation to measure the time it takes the
NQA client to obtain data from an HTTP server.
The expected data is checked only when the data is configured and the HTTP response contains the
Content-Length field in the HTTP header.
The status code of the HTTP packet is a three-digit field in decimal notation, and it includes the
status information for the HTTP server. The first digit defines the class of response.
Configure the HTTP server before you perform the HTTP operation.
To configure the HTTP template:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Create an HTTP template and
enter its view.
nqa template http name
By default, no HTTP templates exist.
3. Specify the URL of the
destination HTTP server.
url url
By default, no URL is specified for the
destination HTTP server.
Enter the URL in one of the following
formats:
•
http:// host / resource.
•
http:// host : port / resource.
4. Specify an HTTP login
username.
username username
By default, no HTTP login username is
specified.
5. Specify an HTTP login
password.
password { cipher |
simple } string
By default, no HTTP login password is
specified.
6. (Optional.) Specify the HTTP
version.
version { v1.0 | v1.1 }
By default, HTTP 1.0 is used.
7. (Optional.) Specify the HTTP
operation type.
operation { get | post |
raw
}
By default, the HTTP operation type is
get , which means obtaining data from
the HTTP server.
If you set the HTTP operation type to
raw
, use the
raw-request
command to
specify the content of the HTTP
request to be sent to the HTTP server.