Error Recovery
5-12
HP Servers Troubleshooting Guide
HP CONFIDENTIAL
Writer: Ted Weiman File Name: f-ch5 Error Recovery.doc
Codename: Generic TSG Part Number: 161759-007 Last Saved On: 11/19/02 9:36 AM
Table 5-2: System Configuration Utility Settings for Booting into Diagnostics
continued
Option Setting
Description
Dial-out string
555-1234
Enter the dial string followed by the remote
computer’s telephone number.
Network status
Enabled
To allow network access to Diagnostics, set
Network Status to Enabled and be sure that the
Reset Boot option is set to Boot Diagnostics.
NOTE:
The Network Status must be set to
Enabled for network access.
Network controller slot
Slot #
Select the slot number of the network interface
controller you wish to use for network access to
Diagnostics.
Network protocol
IP/IPX
To use IPX network access, set Network Protocol
to IPX. When ASR-2 restarts the server to
Diagnostics, it loads IPX network support. This
enables remote access by NVT.
To use IP network access, set Network protocol to
IP. Also be sure to set Network IP address,
Network IP net mask, and Network IP router
address. When ASR-2 restarts the server to
Diagnostics, it loads IP network support, enabling
remote access by Telnet.
Network host name
HP_Server
Enter the network name of the server. Use
underscores instead of spaces within the name, for
example, HP_Server. If you are using IPX network
access to Diagnostics, this server name is used to
advertise NVT host services. This server name is
displayed in the Insight Manager server list when
the system determines that it can communicate by
NVT. Set this name to be the same as the server
name you assign when the host operating system
is running.
Network controller
HP
For all HP standard network controllers.
Network frame type
ETHERNET_II
Select the frame type for your network. Selections
include both Ethernet and IBM Token-Ring
topologies.
continued
