HP ProLiant ML350p Gen8, User Manual

Page: 107 / 145

Hardware options installation 107
9.
Install the TPM security rivet by pressing the rivet firmly into the system board.
10.
If removed, install the PCI card in slot 9.
11.
Install the air baffle (on page 26 ).
12.
Install the access panel (on page 24 ).
13.
Do one of the following:
o
For tower models, return the server to an upright position.
o
For rack models, slide the server back into the rack.
14.
Connect each power cord to the server.
15.
Connect each power cord to the power source.
16.
Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
17.
Do one of the following:
o
For tower models, install the bezel.
o
For rack models, if removed, install the security bezel (on page 21 ).
Retaining the recovery key/password
The recovery key/password is generated during BitLocker™ setup, and can be saved and printed after
BitLocker™ is enabled. When using BitLocker™, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker™ detects a possible compromise of system
integrity.
To help ensure maximum security, observe the following guidelines when retaining the recovery
key/password:
•
Always store the recovery key/password in multiple locations.
•
Always store copies of the recovery key/password away from the server.
•
Do not save the recovery key/password on the encrypted hard drive.