Hardware options installation 100
13.
Fully install the LFF drive cage, and then secure it by tightening the T-15 screws.
14.
Install the fan cage.
15.
Install the air baffle (on page
26
).
16.
For tower models, do the following:
a.
Install the access panel (on page
24
).
b.
Return the server to an upright position.
17.
For rack models, do the following:
a.
Install the rack bezel (on page
23
).
b.
Install the access panel (on page
24
).
c.
Slide the server back into the rack.
18.
Connect each power cord to the server.
19.
Connect each power cord to the power source.
20.
Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
21.
Do one of the following:
o
For tower models, install the bezel.
o
For rack models, if removed, install the security bezel (on page
21
).
Installing the 8 bay SFF drive backplane expander
1.
Do one of the following:
o
For tower models, open and remove the bezel ("
Remove the tower bezel
" on page
21
).
o
For rack models, if installed, remove the security bezel (on page
21
).
2.
Power down the server (on page
20
).
3.
Remove all power:
a.
Disconnect each power cord from the power source.
Summary of Contents for ProLiant ML350p Gen8
