13.
Connect each power cord to the power source.
14.
Power up the server.
Removing and replacing a DIMM
For specific DIMM population information, see the DIMM population guidelines on the Hewlett Packard
Enterprise website (
http://www.hpe.com/docs/memory-population-rules
To identify the DIMMs installed in the server, see "DIMM slot locations" (
on page 92).
Prerequisites
IMPORTANT:
This server does not support mixing RDIMMs and UDIMMs. Attempting to mix these two types causes
the server to halt during BIOS initialization.
Procedure
1.
Power down the server (
on page 33).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
• Extend the server from the rack (
Extend the server from the rack
on page 33).
• Remove the server from the rack (
Removing the server from the rack
on page 34).
4.
Remove the access panel (
on page 35).
5.
If installed, do the following:
a.
Remove the air baffle (
Removing and replacing the air baffle
on page 39).
b.
Remove the processor mezzanine tray (
Removing and replacing the processor mezzanine tray
on
page 43).
c.
Remove the 2P pass-through performance board (
Removing and replacing the 2P pass-through
on page 48).
6.
Remove the DIMM.
Removing and replacing a DIMM
47
Summary of Contents for ProLiant DL560 Gen10
