HP ProLiant DL560 Gen10, Maintenance And Service Manual, Page: 44 / 125

CAUTION:
To avoid damage to the processor or system board, only authorized personnel should attempt to
replace or install the processor in this server.
CAUTION:
To prevent possible server malfunction and damage to the equipment, multiprocessor
configurations must contain processors with the same part number.
CAUTION:
If installing a processor with a faster speed, update the system ROM before installing the
processor.
To download firmware and view installation instructions, see the Hewlett Packard Enterprise
Support Center website .
CAUTION:
THE CONTACTS ARE VERY FRAGILE AND EASILY DAMAGED.
To avoid damage to the socket
or processor, do not touch the contacts.
2. Power down the server ( Power down the server on page 33).
3. Remove all power.
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
• Extend the server from the rack ( Extend the server from the rack on page 33).
• Remove the server from the rack ( Removing the server from the rack on page 34).
5. Remove the access panel ( Removing the access panel on page 35).
6. If installed, do the following:
a. Remove the air baffle ( Removing and replacing the air baffle on page 39).
b. Remove the processor mezzanine tray ( Removing and replacing the processor mezzanine tray on
page 43).
c. Remove the 2P pass-through performance board ( Removing and replacing the 2P pass-through
performance board on page 48).
NOTE:
Depending on the server configuration, your heatsink might appear different.
7. Remove the processor-heatsink module:
a. Allow the heatsink to cool.
b. Loosen the heatsink nuts in the order specified by the label on the heatsink (4 - 3 - 2 - 1).
44 Removal and replacement procedures