Hardware options installation 73
21.
Install the access panel.
22.
Do one of the following:
o
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
23.
Install the hard drives and hard drive blanks.
24.
Power up the server (on page
22
, "
Powering up and configuring the server
" on page
40
).
Removable media device options
The server supports the installation of up to two half-height devices or one full-height device in the removable
media bays.
Installing a half-height media device
1.
Power down the server (on page
22
).
2.
Do one of the following:
o
Open or remove the tower bezel, as needed ("
Open or remove the tower bezel
" on page
22
).
o
Extend the server from the rack (on page
24
).
3.
Remove the access panel (on page
25
).
4.
Remove fan 5 (on page
26
).
5.
If installed, remove the BBWC battery pack or the FBWC capacitor pack (on page
27
).
6.
Remove the air baffle (on page
28
).
7.
Remove the fan cage (on page
29
).
8.
Remove the media bay blank (on page
30
).
9.
Using a T-15 Torx screwdriver, remove the screws from the blank and install them on the device.
Summary of Contents for ProLiant DL G6
