HP PROCURVE 2520, Management And Configuration Manual

Page: 77 / 544

Using the Command Line Interface (CLI)
CLI Control and Editing
Syntax: repeat [cmdlist] [count] [delay]
Repeats execution of a previous command. Repeats the last
command by default until a key is pressed.
cmdlist:
If a number or range of numbers is specified, the
command repeats the n
th
most recent commands (where “n”
is the position in the history list).
count: Repeats the command for the number of times specified.
delay:
The command repeats execution after a delay for the
number of seconds specified.
For example:
ProCurve(config)# repeat 1-4,7-8,10 count 2 delay 3
ProCurve(config)# show history
3
show ver
2 show ip
1 show arp
ProCurve(config)# repeat 1-2
Repeats the show arp and show ip commands.
IP ARP table
IP Address MAC Address Type Port
--------------- ----------------- ------- ----
15.255.128.1 000000-000000
dynamic
Internet (IP) Service
Default Gateway :
Default TTL
Arp Age
Domain Suffix
DNS server
: 64
: 20
:
:
VLAN | IP Config IP Address Subnet Mask Proxy ARP
-------------------- + ---------- --------------- --------------- ---------
DEFAULT_VLAN
| DHCP/Bootp 15.255.131.90 255.255.248.0 No No
Figure 4-11. Example of repeat Command Using a Range
4-17