HP PROCURVE 2520, Management And Configuration Manual

Page: 399 / 544

File Transfers
Transferring Switch Configurations
TFTP: Copying a Customized Command File to a Switch
Using the copy tftp command with the show-tech option provides the ability to
copy a customized command file to the switch. When the
show tech custom
command is executed, the commands in the custom file are executed instead
of the hard-coded list of commands. If no custom file is found, the current
hard-coded list is executed. This list contains commands to display data such
as the image stamp, running configuration, boot history, port settings, and so
on.
Syntax: copy tftp show-tech <ipv4 or ipv6 address> <filename>
Copy a customized command file to the switch.
ProCurve(config)# copy tftp show-tech 10.10.10.3 commandfile1
Figure A-9. Example of Using the copy tftp show-tech Command to Upload a
Customized Command File
Syntax: show tech custom
Executes the commands found in a custom file instead of the
hard-coded list.
Note : Exit the global config mode (if needed) before executing
show tech commands.
You can include
show tech
commands in the custom file, with the exception
of show tech custom . For example, you can include the command show tech all .
If no custom file is found, a message displays stating “No SHOW-TECH file
found.”
ProCurve# show tech custom
No custom file was uploaded with the copy tftp show-
No SHOW-TECH file found.
tech command
Figure A-10. Example of the show tech custom Command
A-25