HP PROCURVE 2520, Management And Configuration Manual

Page: 486 / 544

Troubleshooting
Diagnostic Tools
Timeout in Seconds
is the number of seconds to allow per attempt to test a
connection before determining that the current attempt has failed.
To halt a Link or Ping test before it concludes, click on the Stop button.
To reset the screen to its default settings, click on the Defaults button.
CLI: Ping Test
The Ping (Packet InterNet Groper) test uses Internet Control Message
Protocol (ICMP) echo requests and ICMP echo replies to determine if another
device is alive. It also measures the amount of time it takes to receive a reply
from the specified destination. The Ping command has several extended
commands that allow advanced checking of destination availability.
Syntax: ping <ip-address | hostname | switch-num> [repetitions <1-10000>]
[timeout <1-60>] [source <ip-address> | <vlan-id>] [data-size <0 - 65471>]
[data-fill <0-1024>]
ping6 <ip-address | hostname | switch-num> [repetitions <1-10000>]
[timeout <1-60>] [source <ip-address> | <vlan-id>] [data-size <0 - 65471>]
[data-fill <0-1024>]
Sends ICMP echo requests to determine if another device is alive.
Note : For information about
ping6
, see the “IPv6 Configuration
Guide” for your switch.
<ip-address | hostname>
Target IP address or hostname of the destination node being
pinged.
repetitions <1-10000>
Number of ping packets sent to the destination address.
Default: 1
timeout <1-60>
Timeout interval in seconds; the ECHO REPLY must be
received before this time interval expires for the Ping to be
successful.
Default: 5
source <ip-addr | hostname >
Source IP address or hostname. The source IP address must
be owned by the router. If a VLAN is specified, the IP address
associated with the specified VLAN is used.
C-52