HP PROCURVE 2520, Management And Configuration Manual

Page: 335 / 544

Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
Viewing the Current Configuration
Displaying the Global LLDP, Port Admin, and SNMP Notification
Status.
This command displays the switch’s general LLDP configuration
status, including some per-port information affecting advertisement traffic
and trap notifications.
Syntax show lldp config
Displays the LLDP global configuration, LLDP port status, and
SNMP notification status. For information on port admin status,
refer to “Configuring Per-Port Transmit and Receive Modes” on
page 13-49.
For example,
show lldp config
produces the following display when the switch
is in the default LLDP configuration:
ProCurve(config)# show lldp config
Note: This value corresponds to
the lldp refresh-interval
command (page 13-45).
LLDP Global Configuation
LLDP Enabled [Yes] : Yes
LLDP Transmit Interval [30] : 30
LLDP Hold time Multiplier [4] : 4
LLDP Delay Interval [2] : 2
LLDP Reinit Interval [2] : 2
LLDP Notification Interval [5] : 5
LLDP Fast Start Count [5] : 5
LLDP Port Configuration
Port | AdminStatus NotificationEnabled Med Topology Trap Enabled
----- + ----------- ------------------- ------------------------ -
1 | Tx_Rx False False
2 | Tx_Rx False False
3 | Tx_Rx False False
4 | Tx_Rx False False
5 | Tx_Rx False False
Figure 13-14. Example of Viewing the General LLDP Configuration
13-43