16
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] shutdown
[Sysname-Ten-GigabitEthernet1/0/1] undo shutdown
# Shut down all member ports in the port group named
group1
.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1] shutdown
speed
Use
speed
to set the speed of an Ethernet interface.
Use
undo speed
to restore the default.
Syntax
speed
{
1000
|
auto
}
undo speed
Views
Ethernet interface view
Default command level
2: System level
Parameters
1000
: Sets the interface speed to 1000 Mbps.
auto
: Enables the interface to negotiate a speed with its peer.
Usage guidelines
For an Ethernet copper port, use the
speed
command to set its speed to match the speed of the peer
interface.
Support for this command and parameters of the command varies with device models. For more
information, see
About the Command References for HP Unified Wired-WLAN Products
.
Examples
# Configure interface GigabitEthernet1/0/1 on the HP 830 24-Port PoE+ unified wired-WLAN switch to
operate at 1000 Mbps.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] speed 1000
Layer 2 Ethernet interface configuration commands
broadcast-suppression
Use
broadcast-suppression
to set the broadcast suppression threshold on an Ethernet interface or a
group of Ethernet interfaces.
Use
undo broadcast-suppression
to restore the default broadcast suppression threshold.