13
Views
System view
Default command level
2: System level
Parameters
interface-type
: Specifies an interface type.
interface-number
: Specifies an interface number.
Examples
# Enter Ten-GigabitEthernet 1/0/1 interface view (assuming that the interface is a Layer 2 Ethernet
interface).
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1]
jumboframe enable
Use
jumboframe enable
to allow jumbo frames within the specified length to pass through an Ethernet
interface, a group of Ethernet interfaces, or all Ethernet interfaces.
Use
undo jumboframe enable
to prevent jumbo frames from passing through an Ethernet interface, a
group of Ethernet interfaces, or all Ethernet interfaces.
Syntax
jumboframe enable
[
value
]
undo jumboframe enable
Default
The device allows jumbo frames within a specified length to pass through Layer 2 Ethernet interfaces.
Views
Layer 2 Ethernet interface view, port group view
Default command level
2: System level
Parameters
value
: Sets the maximum size of Ethernet frames that are allowed to pass through. The value range for
this argument is 1700 to 4096 bytes, and the default value is 4096 bytes. If you set the
value
argument
multiple times, the most recent configuration takes effect.
Usage guidelines
In Ethernet interface view, this command applies only to the Ethernet interface.
In port group view, this command applies to the Ethernet interfaces in the port group.
Examples
# Enable jumbo frames to pass through all Ethernet interfaces in port group
group1
.
<Sysname> system-view
[Sysname] port-group manual group1
