Validation
Error/Warning/Prompt
If the username and the key installation user
for that privilege do not match, a message
displays and installation is not allowed.
This will also happen when the
authentication method is set for two-factor.
The username in the key being installed does not
match the username configured on the switch.
If the maximum number of <username : TA
profile> associations is reached for a given
TA profile, a message displays.
Maximum number of username associations with a TA
profile is 10.
If secondary authentication type for two-
factor authentication chosen is not "none", a
message displays.
Not legal combination of authentication methods.
If the authentication method is anything other
than two-factor and the two-factor
authentication method options are set, a
message displays.
Not legal combination of authentication methods.
If two-factor authentication is set and user
tries to SSH into another system using
ssh
<ip | hostname>
command, a message
displays.
SSH client is not supported when the two-factor
authentication is enabled.
If timeSync is in SNTP or Timep when NTP
is enabled.
Timesync is not configured to NTP.
If timesync is NTP and NTP is enabled and
we try to change timesync to SNTP.
Disable NTP before changing timesync to SNTP or
TIMEP.
If we try to configure NTP servers more than
the configured max-associations value.
The maximum number of NTP servers allowed is 2.
If we have ‘n’ NTP servers configured and
we try to configure a max-associations value
less than (n) number of NTP servers already
configured.
Max-associations value cannot be less than the
number of NTP servers configured.
If authentication key-id is not configured.
Authentication key-id %d has not been configured.
If key-id is not marked as trusted.
Key-id %d is not trusted.
If min poll value is more than max poll value. NTP max poll value should be more than min poll
value.
If ipv6 is not enabled on vlan interface.
IPv6 address not configured on the VLAN.
Chapter 2 Time Protocols
61
