exit
vlan 4
name "VLAN4"
no ip address
exit
vlan 5
name "VLAN5"
no ip address
exit
Successfully applied configuration 'config' to running configuration.
cfg-restore config_bkp
Syntax
cfg-restore {tftp <
ip-address
> | sftp <
ip-address
>} config_bkp
Description
Downloads and restores a configuration from the TFTP or SFTP server, without rebooting the switch.
NOTE:
The commands from the restored configuration will be executed on the running configuration.
The name of the current active configuration will not change after a configuration restore.
Command context
config
Example
switch(config)# cfg-restore tftp
HOSTNAME-STR Specify hostname of TFTP Server.
IP-ADDR IP Address of the TFTP Server.
IPV6-ADDR IPV6 Address of the TFTP Server.
switch(config)# cfg-restore sftp
HOSTNAME-STR Specify hostname of the SFTP server.
IP-ADDR IP Address of the SFTP Server.
IPV6-ADDR IPV6 Address of the SFTP Server.
user Specify username on the remote system information
USER@IP-STR Specify username along with remote system
information
switch(config)# cfg-restore tftp 10.100.0.12 pvos/tftp_2930_config_file
Current running-configuration will be replaced with 'tftp_2930_config_file'.
Continue (y/n)? y
Configuration restore is in progress, configuration changes are temporarily disabled.
Successfully applied configuration 'tftp_2930_config_file' to running configuration.
switch(config)# sh cfg-restore status
Status : Success
Config File Name : tftp_2930_config_file
Source : TFTP
Time Taken : 4 Seconds
Last Run : Wed Nov 8 21:11:10 2017
Recovery Mode : Enabled
Failure Reason : -
Number of Add Commands : 4
Number of Remove Commands : 7
Chapter 15 Configuration backup and restore without reboot
567
