<1-5>] [source {<ip-address | source-vlan <vid> | loopback <0-7>}] [dstport
<1-34000>] [srcport <1-34000>] [ip-option {<record-route | loose-source-route |
strict-source-route | include-timestamp | include-timestamp-and-address | include
timestamp-from>}] [< timeout 1-120 >]
Lists the IP address or hostname of each hop in the route, plus the time in microseconds for the
traceroute
packet reply to the switch for each hop.
{< ip-address |
hostname >}
The IP address or hostname of the device to which to send the traceroute.
[minttl < 1-255 >]
For the current instance of
traceroute
, changes the minimum number of hops
allowed for each probe packet sent along the route.
• If
minttl
is greater than the actual number of hops, the output includes only the
hops at and above the
minttl
threshold. (The hops below the threshold are not
listed.)
• If
minttl
matches the actual number of hops, only that hop is shown in the
output.
• If
minttl
is less than the actual number of hops, all hops are listed.
For any instance of
traceroute
, if you want a
minttl
value other than the default,
you must specify that value.(Default: 1)
[maxttl < 1-255 >]
For the current instance of
traceroute
, changes the maximum number of hops
allowed for each probe packet sent along the route.If the destination address is
further from the switch than
maxttl
allows,
traceroute
lists the IP addresses for
all hops it detects up to the
maxttl
limit.For any instance of
traceroute
, if you
want a
maxttl
value other than the default, you must specify that value.(Default: 30)
[probes < 1-5 >]
For the current instance of
traceroute
, changes the number of queries the switch
sends for each hop in the route.For any instance of
traceroute
, if you want a
probes value other than the default, you must specify that value.(Default: 3)
[source {< ip-
addr | vid |
loopback <0-7> >}]
The source IPv4 address, VLAN ID, or Loopback address.
[dstport <
1-34000 >]
Destination port.
Table Continued
Chapter 13 Troubleshooting
531
