displays:
Port A1 does not support IEEE 1588 end-to-end transparent mode.
Use the
command
show ptp
to identify the unsupported ports.
• IEEE 1588 end-to-end transparent mode cannot be enabled on a stack. If the user attempts this, an error
message like the following displays:
IEEE 1588 end-to-end transparent mode cannot be
enabled when stacking is enabled.
• IEEE 1588 end-to-end transparent mode must be enabled or disabled on all ports at the same time.
• MACsec cannot be enabled when IEEE 1588 end-to-end transparent mode is enabled.
• IEEE 1588 end-to-end transparent mode cannot be enabled when MACsec is enabled.
show ptp
Syntax
show ptp [
<port-list>
]
Description
Show IEEE 1588 PTP status.
Command context
Operator
Parameters
port-list
Specifies the ports for which to show PTP status.
Example
switch#
show ptp
Status and Counters - Precision Time Protocol
Port | PTP Config PTP Status RX Count TX Count
----- + ---------- ------------ -------- --------
1/1 | Disabled Inactive 0 0
1/2 | Disabled Inactive 0 0
1/3 | Disabled Inactive 0 0
1/4 | Disabled Inactive 0 0
1/5 | Disabled Inactive 0 0
1/6 | Disabled Inactive 0 0
1/7 | Disabled Inactive 0 0
1/8 | Disabled Inactive 0 0
1/9 | Disabled Inactive 0 0
1/10 | Disabled Inactive 0 0
1/11 | Disabled Inactive 0 0
1/12 | Disabled Inactive 0 0
1/13 | Disabled Inactive 0 0
1/14 | Disabled Inactive 0 0
1/15 | Disabled Inactive 0 0
1/16 | Disabled Inactive 0 0
1/17 | Disabled Inactive 0 0
1/18 | Disabled Inactive 0 0
Monitoring resources
64
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
