Parameter column
Displays
Examples
name
Friendly port name
vlanid
The vlan id this port belongs to, or "tagged" if it
belongs to more than one vlan
4tagged
enabled
port is or is not enabled
yes or nointrusion
intrusion
Intrusion alert status
no
bcast
Broadcast limit
0
The custom show interfaces command
switch(config)# show int custom 1-4 port name:4 type vlan intrusion speed enabled mdi
Status and Counters - Custom Port Status
Intrusion
Port Name Type VLAN Alert Speed Enabled MDI-mode
---- ---------- ---------- ----- --------- ------- ------- --------
1 Acco 100/1000T 1 No 1000FDx Yes Auto
2 Huma 100/1000T 1 No 1000FDx Yes Auto
3 Deve 100/1000T 1 No 1000FDx Yes Auto
4 Lab1 100/1000T 1 No 1000FDx Yes Auto
You can specify the column width by entering a colon after the column name, then indicating the number of
characters to display. In the above example, the Name column displays only the first four characters of the name.
All remaining characters are truncated.
NOTE:
Each field has a fixed minimum width to be displayed. If you specify a field width smaller than
the minimum width, the information is displayed at the minimum width. For example, if the minimum
width for the Name field is 4 characters and you specify Name:2, the Name field displays 4
characters.
You can enter parameters in any order. There is a limit of 80 characters per line; if you exceed this limit an error
displays.
Error messages associated with the show interfaces command
The following table provides information on error messages associated with the
show interfaces custom
command.
Error
Error message
Requesting too many fields (total characters exceeds
80)
Total length of selected data exceeds one line
Field name is misspelled
Invalid input: <
input
>
Mistake in specifying the port list
Module not present for port or invalid port: <
input
>
The port list is not specified
Incomplete input: custom
74
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
