Viewing port configuration details (CLI)
Syntax:
show lldp config <
port-list
>
Displays the LLDP port-specific configuration for all ports in <
port-list
>, including which optional TLVs and any
non-default IP address that are included in the port's outbound advertisements.
For information on the notification setting, see
Configuring SNMP notification support
on page 227. For
information on the other configurable settings displayed by this command, see
on page 228.
Figure 30: Per-port configuration display
Configuring Global LLDP Packet Controls
The commands in this section configure the aspects of LLDP operation that apply the same to all ports in the
switch.
LLDP operation on the switch
Enabling LLDP operation (the default) causes the switch to:
• Use active, LLDP-enabled ports to transmit LLDP packets describing itself to neighbor devices.
• Add entries to its neighbors table based on data read from incoming LLDP advertisements.
Enabling or disabling LLDP operation on the switch (CLI)
For more information, see
Syntax:
[no] lldp run
224
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
