Media alignment
Align load is a special loading procedure to register markers, so that pre-printed jobs can be contour-cut. This
parameter is explained in
Register the markers on page 29
.
Settings
Velocity
This menu groups all the parameters that affect the throughput of the cutter. The velocity and acceleration
settings are explained in
Set the cutting speed on page 20
.
Overcut
The Overcut submenu enables you to generate an overcut to facilitate weeding the cut. Each time the knife goes
up or down, the cutter cuts a bit further. The illustration below shows what overcut can do with a tangential
knife. A sample cutout with a drag knife would show fewer overcuts as there would be fewer up/downs (usually
only one per curve/letter). The overcut setting can be disabled (=0) or set to any value between 0 (=off) and 10.
One unit is about 0.1 mm (0.004 in).
Press
. Use
or
to change the value. Press
to confirm or
to cancel. The default overcut is
set to 1.
OptiCut
OptiCut improves the cutting quality if the knife is worn out or not calibrated correctly.
Press
. Use
or
to set OptiCut on or off. Press
to confirm or
to cancel. OptiCut is off by
default.
36
Chapter 5 Detailed operation of the cutter
ENWW
Summary of Contents for 54 Basic Cutter
Page 1: ...HP Latex Cutter Series User Guide ...
Page 37: ...ENWW Introduction 33 ...
