9.
Check that the result is satisfactory. If not, change one of the above parameters. Reducing the velocity can
improve the result. You are recommended never to use cutting speeds greater than 400 mm/s (16 ips) with
cutting pressures above 170 g.
NOTE:
It is not always easy to find the correct balance between cutting deep enough (ensuring that the
pieces can be taken out easily) and not cutting too deep (ensuring that the substrate keeps its strength
while cutting). Sometimes this balance does not exist, meaning that this substrate cannot be cut through
with satisfactory results.
NOTE:
FlexCut parameters are always metric, regardless of the value of the Units parameter.
TIP:
When cutting through, parallel lines are recommended to be at least 1 cm away from each other.
Otherwise, while cutting the second line, the first line may come loose and cause trouble.
10.
Press
to confirm.
11.
Press
to leave the FlexCut menu.
12.
Press
or
to scroll through the menu until you reach Panels. Press
.
13.
Press
or
to choose the panel parameter to be changed.
14.
Press
or
to change the value of the chosen parameter.
TIP:
Recommended settings are: Panels: On; Panel size: 3–10 cm; Recut: Off; Sorting: On.
15.
Press
to confirm. An asterisk appears by the value, indicating that it is now selected.
16.
Press
twice.
ENWW
Detailed OPOS operations
31
Summary of Contents for 54 Basic Cutter
Page 1: ...HP Latex Cutter Series User Guide ...
Page 37: ...ENWW Introduction 33 ...
