NOTE:
Although the OPOS sensor has been calibrated in the factory, HP recommends doing a test to determine
how well the factory-set parameters work with the materials you are using. If the accuracy is not satisfactory,
then do the OPOS calibration.
Change the origin
●
Press
,
,
, or
to change the origin.
The substrate moves to the new origin, and values appear on the screen. The X value is the distance from
the original origin; the Y value is the maximum cutting width.
●
Press
to toggle the Y value between the maximum cutting width and distance from the original origin.
●
Press
to toggle between the maximum cutting length and the distance from the original origin.
The X and/or Y value toggles.
●
Press
if you have reached the desired origin.
The cutter comes online and is ready to receive data from the computer.
●
Or press
to cancel.
The cutter moves to its original origin and comes online.
Extended load
The extended load function makes it possible to define the limits of the Y axis so that the cutter can cut outside
the pinch rollers. Substrate has to be loaded before this function can be used.
1.
Press
.
2.
Press
. System setup appears on the screen. Press
.
3.
Press
> Actions. Press
.
4.
Press
or
to scroll through the menu until you reach Extended load.
5.
Press
or
to define the new limit at the right (origin). The head moves to its new origin.
6.
Press
. Size appears on the screen.
7.
Press
or
to define the new limit at the left.
8.
Press
.
NOTE:
Tracking is not guaranteed when using this mode.
ENWW
Change the origin
27
Summary of Contents for 54 Basic Cutter
Page 1: ...HP Latex Cutter Series User Guide ...
Page 37: ...ENWW Introduction 33 ...