Horizon Reverse Osmosis Seafari Versatile SFC-1400-2, Owner'S Manual

Page: 96 / 162

HRO
Systems
Horizon
Seafari
“Section J” System & R.O. Membrane Element Storage Procedure
5. Fill the Rinse/Clean Tank [50] full with non-
chlorinated product water. The cleaning tank
must contain enough product water to displace all
of the feed water. This requires approximately
10 - 20 gallons (38 - 75 liters).
6. Position the Rinse/Clean Outlet Valve [35] to the
Brine Discharge (normal operation) position.
7. Open the Back Pressure Regulating Valve [33]
full open counter clockwise.
8. Start the system. The rinse water is now rinsing
the entire system and discharging to waste.
9. Apply 200 psi of pressure to the System. This
produces a minimal amount of product water,
which ensures the product water line remains
wet.
10. Just prior to depleting the rinse water from the
tank, stop the system.
11. Open the Back Pressure Regulating Valve [33]
full open.
12. Add 10 - 20 gal. (8 - 15 liters) of product water
to the Rinse/Clean Tank.
13. Fill a separate plastic bucket or container with 1
to 2 gallons of product water. Add the HRO SC
Storage Chemical to the water in the bucket as
follows:
Mix and thoroughly dissolve the solution in the
container. Pour the dissolved solution contents
into the Rinse/Clean Tank [50].
NOTE: The correct mixture ratio for the Storage
Chemical (SC) is one bottle per 20 gallons of
product water. The chemical is mixed first in a
small bucket and then added to the water in the
tank. This makes the chemical easier to dissolve
into the water.
Mixture example 1: If the Rinse/Clean Tank
[50] contains 10 gallons of product water then
add 1/2 bottle of the SC Storage Chemical.
Mixture example 2: If the Rinse/Clean Tank
[50] contains 20 gallons of product water then
add a full bottle of the SC Storage Chemical.
Page J - 5