Horizon Reverse Osmosis Seafari Versatile SFC-1400-2, Owner'S Manual

Page: 47 / 162

HRO
Systems
Horizon
Seafari
“Section E” Installation
Connect the Booster Pump Outlet (or Plankton
Filter Outlet if used or Multi Media Filter Outlet
if used) to the Pre-filter Inlet.
If the Oil/Water Separator is not used then
connect the Standard Pre-filters Outlet to the
High Pressure Pump Inlet.
11. Commercial Pre-filter [14] replaces the Standard
Pre-filters.
It is not necessary to use both the Commercial Pre-
filter and Standard Pre-filters.
The Commercial Pre-filter, must be positioned on
a firm, flat surface and mounted in place with the
supplied hardware.
Allow 12 inches above the Commercial Pre-filter
assembly for filter element removal.
Connect the Commercial Pre-filter Inlet Port to the
Booster Pump Outlet (or Plankton Filter Outlet if
used or Multi Media Filter Outlet if used).
12. Oil/Water Separator [17] follows the
Commercial Pre-filter.
Outlet Pressure
Pick-Up
Plumb to Pigtail on
rear of control
manifold with
supplied ¼” tubing.
See pg. E-11 for
location of pigtail on
control manifold.
The Oil/Water Separator Assembly is plumbed for
water flow in the opposite direction as the Pre-
filter.
Using the supplied ¾” hose, connect the Oil/Water
Separator Inlet to the Standard or Commercial Pre-
filter Outlet.
Connect the Oil/Water Separator Outlet to the
High Pressure Pump Inlet.
13.
Self-Contained or Modular System mounting:
Must be readily accessible for daily operation and
periodic maintenance.
Components within the system must be readily
access able for maintenance.
Ensure that all tubing and hoses are routed
without kinks or sharp bends.
Mount the System on a firm flat surface and
secure in place.
Modular System mounting:
The controls within the System must be readily
accessible for daily operation.
Ensure that all tubing and hose connections have
sufficient space to be routed without kinks or
sharp bends.
Water Flow
Water Flow
Page E - 15