Horizon Reverse Osmosis Seafari Versatile SFC-1400-2, Owner'S Manual

Page: 43 / 162

HRO
Systems
Horizon
Seafari
“Section E” Installation
I. COMPONENT INSTALLATION:
INSTALLATION CAUTIONS:
Do not over tighten PVC fittings. If threaded pipe
fittings leak after installation then remove the
fitting, clean the male mating threads, apply 3 to 4
wraps of Teflon tape to the male threads and then
thread the parts back together.
The Inlet Connection [1], Sea Strainer [3], Inlet
Clean/Rinse Valve [4] and Booster Pump [5] must
be mounted below water level to operate properly.
REMOVE ALL TUBE SHIPPING PLUGS
FROM THE RIGHT SIDE OF THE HORIZON
SEAFARI
.
Always use 2 supplied Hose Clamps at each
connection to secure the hose to its respective Hose
Barb Fitting and seal it from leaks.
Always allow the tube to enter and exit straight
from the tube fitting for a minimum of one inch
prior to starting a bend.
DO NOT tie or tee the Horizon Seafari System
Feed Line into another line that already feeds
another auxiliary system.
DO NOT tie or tee another auxiliary system into
the Horizon Seafari System Feed Line.
DO NOT mount the R.O. Membrane assembly in
areas with temperatures above 120
°
F / 40 C or in
freezing temperatures. Do not mount the MVA in
areas exposed to radiant heat above 120
°
F / 40 C.
Avoid skin and eye contact with the storage
solution the membrane is packaged in. In case of
skin contact, rinse the skin thoroughly with water.
In case of eye contact, flush repeatedly with water
and notify a physician immediately.
1. Inlet Thru Hull Fitting [1] with Inlet Sea Cock
Valve [2]
The Sea Cock Valve [2] must be fitted with 3/4"
MNPT (Male National Pipe Taper, i.e. American
Standard Tapered Pipe Thread) at the Sea Cock
Valve’s outlet.
The Thru Hull Fitting must be located well below
the water line so the inlet remains in constant
contact with the feed water even while vessel is
under way.
Remove Plug from Brine
Discharge Fitting
Remove Plug From Product
Outlet Fitting
NOTE: ON THE REAR OF THE CONTROL
MANIFOLD THERE IS A PIGTAIL WHICH IS
CONNECTED TO THE LOW PRESSURE
GAUGE. CONNECT THIS PIGTAIL TO THE
OUTLET OF THE FINAL FILTER PRIOR TO
THE HIGH PRESSURE PUMP.
Page E - 11