Horizon Reverse Osmosis Seafari Versatile SFC-1400-2, Owner'S Manual

Page: 52 / 162

HRO
Systems
Horizon
Seafari
“Section F” System Commissioning & Initial Startup
Page F - 1
F. SYSTEM COMMISSIONING
INITIAL START-UP PROCEDURE OF A NEW
HRO Systems Horizon Seafari.
Throughout this Manual, Numbers in
[ brackets ] refer to the I.D. numbers illustrated on page
F - 2.
The following instructions must be carried out for initial
start-up of a NEW system. For every day use starting
procedures, refer to Section "G" "Start-Up Procedure" of
this manual.
Failure to follow these instructions exactly leads to
system failure, and causes damage to the components.
Read this section and other appropriate sections of the
manual in order to gain familiarity with the requirements
of the system and functions of each component.
AVOID CHEMICAL ATTACK TO THE SYSTEM
CAUTION: Do Not expose the Horizon Seafari system to intake Feed Water that contains:
Hydrogen peroxide chloramines chloramines-T N-chlorioisocyanurates
Chlorine dioxide hypochlorite chlorine iodine
Bromine Bromide phenolic disinfectants petroleum products
Any chemical, not approved in writing by HRO Systems
.
USE OF NON-AUTHORIZED OR MISUSE OF AUTHORIZED CHEMICALS VOIDS SYSTEM WARRANTY.
Do not connect any water line to the Horizon Seafari system that may contain any of the above listed chemicals.
Example:
Do not connect the inlet of the Horizon Seafari system to the ships potable water system if the system contains
chlorinated or brominated water. These chemicals destroy the copolymer components within the system. These
oxidants and others also damage the R.O. Membrane Element.
High Pressure Pump Preparation:
•
The high Pressure Pump is shipped with a red
Non-Vented Plug so that oil does not leak during
shipment.
•
This red color Non-Vented Plug (located on the
top of the black color rear crankcase section)
must be replaced with the supplied Vented Oil Fill
Cap.
•
If the crankcase is not vented with the proper cap,
pressure builds within the crankcase and causes
seal failure, loss of oil, and ultimately failure of
the High Pressure Pump.
•
Failure to replace the shipping cap with the
supplied Vented Oil Fill cap voids all Warranty of
the High Pressure Pump. Installer will bear full
responsibility for all damages resulting from
failure to install the supplied High Pressure Pump
Oil Fill Vented Cap.
Supplied Orange-Colored
Vented Oil Fill Cap Must Be
Installed Prior to Use.