Horizon Reverse Osmosis Seafari Versatile SFC-1400-2, Owner'S Manual

Page: 56 / 162

HRO
Systems
Horizon
Seafari
“Section F” System Commissioning & Initial Startup
1. Ensure that all Tube Plugs and shipping caps have been
removed prior to commissioning. Failure to remove
these caps could cause damage to the system.
2. Check the level of the oil in the High Pressure Pump
crankcase. Ensure that the oil level is higher than the
center of the sight glass.
Use only HRO supplied Pump Oil as it is special
hydraulic oil, which contains anti rust and wear
inhibitors essential to the high-pressure pump
crankcase section.
3. Check each tube connection at the side panel of the
System to ensure that the installer has properly
connected and properly routed each tube. Improper
routing and any blockage in any line causes damage
to the system. Do not rely on the installers word,
check it yourself.
4. Make sure that the Electrical Power Source to the
System is switched "OFF".
Page F - 5
5. Open the front panel of the Main Power Enclosure.
Check all connections for proper wiring and
attachment. Refer to the wiring diagrams in
APPENDIX A - 3 through A - 6.
6. Close the Main Power Enclosure front panel.
7. Ensure that the manual By-Pass lever on the Diversion
Valve [43] is positioned outward (away from the coil
body). The manual bypass lever may be locked in
the bypass position by pressing it in fully and then
twisting 90
°
clockwise. To unlock, twist the button
90
°
counter-clockwise. See diagram to the right for
location of the access hole to the Diversion Valve
[43].
8. Close the Commercial Pre-filter [14] drain valve, if
installed.
9. Close the Oil/Water Separator [17] Drain Valve, if
installed.
10. Close the air bleed valve located on top of the
Commercial Pre-filter [15], if installed.
11. Close the air bleed valve located on top of the
Oil/Water Separator [17], if installed. Open the
Inlet Sea Cock Valve [2] fully.
12. Position the Clean/Rinse Inlet Valve [4], if installed,
to the normal operating position towards the Sea
Strainer [3] Outlet.
13. Position the Clean/Rinse Outlet Valve [35], if
installed, to the normal operating position towards
the Brine Discharge Outlet [36].
14. Open any auxiliary Valve within the incoming Feed
Line; Outgoing Brine Discharge Line; and
Outgoing Product Water Line.
CAUTION: Any auxiliary Valve in these lines
damages the Horizon Seafari if left closed during
starting and or operation of the System.
Diversion Valve Manual
Bypass Lever
Horizon Seafari Control Panel
Replace Shipping Cap with Orange
Vented Cap Supplied on the High
Pressure Pump.
High-Pressure Pump Assembly.