Horizon Reverse Osmosis Seafari Versatile SFC-1400-2, Owner'S Manual

Page: 33 / 162

HRO
Systems
Horizon
Seafari
“Section E” Installation
Page E - 1
E. INSTALLATION OF HORIZON
SEAFARI SYSTEMS
ON SITE STORAGE & PREPARATION FOR
INSTALLATION:
A. STORAGE PRIOR TO UNCRATING:
1. Adhere to crate markings:
•
DO NOT store in direct sunlight;
•
DO NOT store above 120 degrees F / 50
degrees C;
•
DO NOT freeze; STORE ONLY on base with
ARROWS UP;
•
DO NOT store longer than 3 months without
additional storage chemical rinsing.
2. Refer to Section J of this manual for further cautions
of the R.O. Membrane Element.
B. AVOID CHEMICAL ATTACK TO THE
SYSTEM:
CAUTION: Do not expose the Horizon Seafari.
System to:
hydrogen peroxide
chloramine
chloramine-T N-chloroisocyanurates
chlorine dioxide hypochlorite, chlorine
iodine bromine
bromide phenolic disinfectants
or any other specific chemical not approved in
writing by HRO Systems. Use of unauthorized or
misuse of authorized chemicals voids system
warranty.
Numbers in [ brackets ] refer to the I.D. numbers
illustrated on page D-2.
C. COMPONENTS SUPPLIED BY OWNER:
1.
Inlet Thru Hull Fitting with Inlet Sea Cock Valve
[1&2]
- ¼ - turn ball valve min. ¾” size, with a ¾”
MNPT connection for the supplied HRO fitting.
-
This inlet must be installed below water level
and must never be able to draw air
-
The system intake must be located toward the
bottom when a stand up pipe is used.
2. Brine Thru Hull Fitting [36]
- A minimum ½” size with a ½” MNPT
connection.
- Must be located above water level.
- If a Multi-Media Filter is installed, an additional
waste fitting, minimum ½” size with ½” MNPT
for connection to the supplied HRO fittings.
3.
Potable Water Storage Tank [46]
- The installation fitting must be at least a 3/8”
NPT with 3/8” FNPT for connection of the HRO
fittings.
- The fitting must terminate above the maximum
water level.
- No valves should be installed in this line.
4.
Properly sized Power Cable:
Operating Voltage 115 VAC, Single Phase,
Recommended Minimum Size Power Cable:
10 AWG
Operating Voltage 230 VAC, Single Phase,
Recommended Minimum Size Power Cable:
12 AWG
Operating Voltage 230 VAC, Three Phase,
Recommended Minimum Size Power Cable:
12 AWG
Operating Voltage 380-460 VAC, Three Phase,
Recommended Minimum Size Power Cable:
14 AWG
5.
An electrical power source capable of supplying
the proper current at the proper Voltage to the
Horizon Seafari System.