Horizon Fitness BQ-150, Manual

Page: 27 / 45

22
2. Operation Procedure
2-2 Achieving Good Quality Binding
4.
Turn off the roughening cutter ON/OFF
switch.
NOTE
- If the roughening cutter monitor lamp is lit
when the roughening cutter switch is set to
OFF, operate the roughening cutter ON/OFF
switch several times until the roughening
cutter monitor lamp goes out.
5.
Place an A4 sheet instead of a book block
into the clamper and align it with the left
side of the clamper. The clamper close
lamp will light.
6.
Close the clamper by pressing the clamper
close button.
NOTE
When the clamper is completely closed, the
light in the clamper close button goes out and
the start lamp lights.
7.
Press the start button.
- After the clamper has reached the left end
of its travel, it returns to the home position.
- Air is blown onto the spine of a sheet for
15 seconds to solid glue, and then the lamp
in the clamper open button lights.
8.
Press the clamper open button.
- The clamper opens, the light in the clamper
open button goes out, and the reset lamp
lights.
9.
Remove A4 sheets by lifting upward.
NOTE
- After the book has removed from the
clamper, the nipper is reset automatically.
10.
Repeat the steps 5 to 9 to stir the hot-melt
glue to improve uneven temperature of
glue in the tank.
Clamper Close Button
Reset Lamp
Start Lamp
Start Button
Clamper Open
Button
Place an A4 sheet
instead of a book block
Remove an A4 sheet
by lifting upward.
Roughening Cutter
Monitor Lamp
Roughening Cutter ON/OFF Switch
OFF