Installation
BA_sun_power_pack_LiOn_en_V1.05.docx
V1.05 (20/07/2017) 6140203036
26
2. Check the battery stacks for visible signs of damage.
WARNING!
The battery stacks with apparent signs of damage must not be installed or connected to the BMS!
CAUTION!
The battery stacks and the battery cells that they contain should not be disassembled or opened
under any circumstances.
3. Remove the cover of the housing. To do this, loosen the Allen screws at the bottom
of the cover (see Figure 10).
No. Description
1
Left fastening screw
2
Right fastening screw
Figure 10: Fastening screws on the cover
4. Push the battery stacks one after the other into the housing of the battery system.
Use the carry grips fixed on the sides to lift the battery stack (see Figure 11 and
Figure 12). Begin with the lower level (see Figure 13).
Note:
Each battery stack is marked on the front side, among others, with a serial number. Each of the
housing levels is also marked with the serial number of the battery stack assigned to it (see the
inside of the housing) to know which battery stack needs to be installed in each level of the
housing.
