Honeywell SMV800, User Manual

Page: 136 / 220

Page 124 SMV800 Modbus User's Guide Revision 1.0
Information 120
Bit - 3
ts_sensor_over_
temperature The Process Temperature
input exceeds
the Temperature Upper
Range Limit
(URL) as determined by
the configured
Sensor Type. Check the process
temperature. If the
process temperature
exceeds the range of
the current sensor type,
either correct the
process to an in-range
temperature or switch to a
different sensor type which
is ranged for the expected
process temperature
range.
Bit - 4
excess_cal1_co
rrection The temperature
calibration correcs on LRV,
URV or both is in excess. Perform Reset Corrects to
reset the User calibration
to factory default. If
required, fllow the
calibration procedure to
repeat the temperature
calibration.
Bit - 5
user_corrects_a
ctivated User Corrects Activated This is acknowledgement
status for reset corrects
performed by user
Bit - 6
bad TV Temperature module input
bad. Input out of range or
may be open Use matching sensor
suitable for the process
range. Reset the device,
replace the Temp Module if
issue persists
Bit - 7
bad SV Temperature Module CJ
measurement is bad Verify that the CJ sensor
within the Temp sensor
module is not outside of
the operating temp limits (-
40 to 85 degC). Reset the
device, replace the Temp
Module if issue persists
Bit - 8
Input1_fault Fault is set if Temperature
module
• input failue faulty sensor,
• out of range
• input open Replace the faulty sensor if
that is the reason. Select
suitable sensor type for the
process. Reset the device,
replace the Temperature
Module if issue persists
Bit - 9
low_sensor_sup
ply Temperature module
Supply is Low Check supply voltage is
within specification. If all
are within specification,
replace Temperature
module
Bit 10-
11 Unused NA NA