HTRD400 System Reference Guide
Rev 1.02
81
Document 900.0328
05/05
To erase the hard drive:
1.
On the Administration tab, click either:
2.
Depending on whether you have chosen a Quick Erase or a Full Erase, one of the
following warnings displays. Click OK to start the erase procedure.
Upgrading the Recorder and Camera Firmware
To upgrade the firmware, please consult Honeywell Video Systems Technical Support (see
Quick Erase
Full Erase
to have the recorder reset to the start of the
disk. Each new image recorded after a
quick erase overwrites the oldest image. It
takes approximately ten seconds to do a
quick erase.
to have the application carry out a sector by
sector disk erase.
We recommend that you periodically
archive any clips you may need in the future
before doing a quick erase (see
All the Clips on the HTRD400 Recorder Hard
Drive
).
When the recorder starts a full disk erase, it
remains powered while it completes the
erase activity, regardless of any wakeup
condition. The Record LED on the front
panel blinks rapidly to indicate that a full
disk erase is in progress. This can take at
least 4.5 hours depending on the capacity
of the hard drive.
Quick erase warning
Full erase warning
Summary of Contents for HTRD400
