Honeywell DL230, Operating Instructions Manual

Page: 60 / 104

60 Operation
Code Description
11 Entry based on specific setting or configuration not possible,
e.g. The input of
Vo is not possible in encoder mode.
12 The input of this source (address) is not permitted.
13 Entry based on specific setting or configuration not possible,
e.g.:
The " Clr.X " function can only be performed once the time has
been set to its start value with the key combination
+ (initialized).
20 Value for the user-specific display is not defined
The value to be displayed can be defined by the user by
entering the address. As this address has not yet been
entered, no value will be displayed.
21 The value can only be changed when the calibration lock is
open as the PTB log is full.
6.3.6
Access rights
The following parties can access the DL230.
Access Description
PL Calibration officer
CDL Certification Data Log
A Administrator
C Customer
- No access
Each access party has one lock and a corresponding key.
The access rights apply for entries made via the keyboard, and for access
via the optical or integrated modem interface. If the lock is closed, all
attempts to enter values will result in a corresponding error message being
displayed (see chapter 6.3.5, "Error messages when entering values").
For data protection reasons, reading values from the interfaces is only
possible if at least one of the locks is open.