Performance Series Network Video Recorder User Guide
88
Figure 8-11 Network Abnormality Configuration Tab
2.
On the
Network
tab, in the
Event Type
box, select the event type for which you want to
configure settings:
Disconnect
,
IP Conflict
,
MAC Conflict
.
3.
Select the
Enable
check box to enable network error detection for the selected event type.
4.
Select the actions that you want the system to initiate when the selected event occurs:
Alarm Out:
Select the check box to activate the selected alarm output(s) (
1
or
2
). In the
Latch
box, specify the amount of time (0–300 s) to delay the alarm output signal after the
network event is triggered.
Show Message:
Select the check box to enable a pop-up message on your local host PC.
Send Email:
Select the check box to enable the system to send an email notification. To
set up Email settings, see
Voice Prompts:
Select the check box to enable the playing of a voice prompt audio file
when a network event is triggered. Use the
File Name
drop-down arrow to select the audio
file to play for network events.
Buzzer:
Select the check box to activate a buzzer noise at the NVR.
Log:
Select the check box to enable logging of network events.
5.
Click
Apply
to save your settings.
Configuring Username Settings
1.
Go to
Main Menu
SETTING
EVENT
ABNORMALITY
Username
.
Summary of Contents for 2450Cm Series
Page 2: ......
Page 27: ...Getting Started 13 ...
Page 28: ...Performance Series Network Video Recorder User Guide 14 ...
Page 29: ...Getting Started 15 ...