Performance Series Network Video Recorder User Guide
250
Note
The procedure for installing an additional hard drive is similar
to the installing hard drive sections above, but different
depending on what NVR unit you have. Check the model
number of your NVR and make sure that you refer to the steps
in the section that applies to your NVR unit when installing an
additional HDD:
Installing a HDD on HEN081*4/HEN161*4/HEN321*4
Installing a HDD on HEN162*4/HEN322*4/HEN642*4
Installing a HDD on HEN163*4/HEN323*4/HEN643*4
1.
If the NVR is connected to a power source, disconnect it before continuing.
2.
Remove the top cover from the NVR housing as described in the Installing HDD section
for your unit. Refer to the corresponding section:
• HEN081*4/HEN161*4/HEN321*4 on
• HEN162*4/HEN322*4/HEN642*4 on
• HEN163*4/HEN323*4/HEN643*4 on
3.
Connect the SATA and power cables to the new HDD.
4.
Position the new HDD over the four open screw holes in the base of the housing or HDD
bracket (depending on your NVR model), adjacent to the existing HDD.
5.
Secure the new HDD to the housing using the four supplied HDD mounting screws.
6.
Replace the NVR top cover on the NVR housing and secure it with the screws removed in
step 2.
Summary of Contents for 2450Cm Series
Page 2: ......
Page 27: ...Getting Started 13 ...
Page 28: ...Performance Series Network Video Recorder User Guide 14 ...
Page 29: ...Getting Started 15 ...