Honda Miimo HRM310, Owner'S Manual

Page: 33 / 88

4 MENU SETTINGS
31
Setting the lawn mower operation
Setting the lawn mower operation
Auto mode
You can set up the lawn mower operation as follows:
Point 1
Point 2
Point 3
Point 4
Point 5
Setting the value to reach other areas through the
narrow passage
The lawn mower can reach other areas through narrow
passages with the following settings:
- Con
fi gure the value of the narrow passage distance from
the docking station. When passing the con fi gured narrow
passage, the lawn mower closely follows the boundary wire.
This is effective for 4 or fewer narrow pathways in the lawn.
L
Width settings in [1.Mowing start points] (
M
page 33)
L
[4.Narrow passage] in [4.Advanced setting] (
M
page 37)
NOTE:
- [4.Narrow passage] setting is for going toward the starting
point. If you want to con fi gure the setting for returning to
the docking station, you need to set it in the Homing setup.
For details, see “Homing setup” (
M
page 41).
Setting the overlap
distance on the
boundary wire
Set the distance that the
lawn mower can cross
the boundary wire.
L
[1.Wire Overlap] in
[4.Advanced setting]
(
M
page 34)
NOTE:
- To have the lawn mower
smoothly turn from
the boundary wire, the
recommended value of the
Wire overlap is 7.9 in (20 cm).
Setting the distance to the start point
Until the lawn mower reaches a set starting point in an
area, it will run without mowing.
L
Distance settings in [1.Mowing start points]
(
M
page 33)
- Sets the distance from the docking station to start
cutting.
Setting the starting
direction from the
docking station
Set whether the lawn
mower should travel
clockwise or counter-
clockwise along the
boundary wire to reach a
set starting point.
L
(Clockwise) or
(Counter-clockwise)
in [1.Mowing start
point]
(
M
page 33)
Setting the angle to turn from the boundary wire
When leaving the boundary wire, set the angle to turn
from the boundary wire.
L
Angle settings in [1.Mowing start points] (
M
page 33)
- Set the angle of departure for when the lawn mower
arrives at the position speci fi ed by the angle of
[1.Mowing start point].
Setting the operation ratio of each area
operation
Set an area operation ratio if you want to mow more
frequently from a certain start point.
For example, if you set the ratio for “Point 1” to 30%,
the lawn mower will start mowing 3 times out of 10
from “Point 1” and 7 times out of 10 from other start
points.
L
Percentage settings in [1.Mowing start points]
(
M
page 33)
NOTE:
- You can con fi gure the following start points for
each model:
HRM310: 3 start points
HRM520: 5 start points
NOTE:
- If you want to operate the lawn mower with [Auto mode], see “Operating the lawn mower with the Auto mode.”
(
M
page 55).