5 USAGE
53
Checking the mowing area / Connecting to a power source
5
USAGE
Checking the mowing area
Before operating the lawn mower, ensure the mowing area is free of
pets and foreign objects.
Turn off the lawn mower before removing any foreign objects.
NOTE:
- If there are any holes in the work area,
fi
ll them in so that the
work area is level. Periodically check the work area for holes.
Adjust the height of the grass and blades as follows.
NOTE:
- If the grass height is 0.2 in. (5 mm) longer or more than the grass
height you want to maintain, use standard lawnmowing equipment to
cut the grass before using the lawn mower.
The lawn mower cuts up to 0.2 in. (5 mm) at a time. Adjust the height
of the lawn mower so that the mowing length is within 0.2 in. (5 mm).
(
Grass
height to
ma
0.2 in. (5 mm)
or less
(up to 2.6 in.
(65 mm))
Connecting to a power source
Follow the steps below when connecting to a power source.
Follow these steps in reverse when disconnecting from a power source.
For details on moving the transformer or changing to a different power outlet, contact your dealer.
NOTE:
- Connect the station only to a supply circuit protected by a residual current device (RCD) with a tripping
current of not more than 30 mA.
- Check that all of the cables up to the station are connected, and then connect the transformer to a power outlet last.
- Preferably, the primary side (Power outlet side) cable of the transformer should not be extended.
- Do not extend the secondary side (not Power outlet side) cable of the transformer to the length of the
included extension cable (10 m) or longer.
- Do not damage the body or cable when securing the transformer.
- Push in the connectors of the transformer and extension cable until the hook is locked in place.
1
Remove the connector cover from the station.
2
Connect the power cord connector to the station’s internal connector.
NOTE:
- When disconnecting the connectors, make sure to lift the clip.
