�HONDA
� MBX50· MBX80
JETS/FLOAT VAlV[/flOAT ASSEMBLY
Install the needle jet, needle jet holder and main jet.
Install the air and stop screws by turning them into
their original positions.
Install the choke (starter) valve.
Install the float valve, float and float pin.
CAUTION
I Insert the float pin in the arrow direction.
Check the float for operation. Install the float
chamber.
FLOAT lEVEl ADJUSTMENT
Measure the float level with the float tip just con
tacting the float valve.
FLOAT LEVEL: 13.5 mm (0.53 in) ±1.0 mm
Replace the float assembly if not within specifica
tion.
FUEL SYSTEM
(1) SLOW JET
(2) MAIN JET
(3) STOP SCREW
(4) AIR SCREW
(1) FLOAT PIN
(2) FLOAT VALVE
(3) FLOAT
(4) CHOKE
(STARTER VALVE)
(1) FLOAT GAUGE
4-7
Summary of Contents for MBX50
