HYDRAULIC BRAKE
Clean the brake caliper.
Apply silicone grease to the pin bolts and pins on
the caliper bracket.
Install new brake pads and pad spring and loosely
install the pin bolts.
CAUTION
Replace both pads as a set. Do not replace
one without replacing another.
Ensure that the pin bolts are inserted through the
holes in the brake pads.
Assemble the caliper bracket and caliper and install
the caliper on the fork leg.
TORQUE: 24-30 N.m (2.4-3.0 kg-m,
17-22 ft-lb)
Tighten the pin bolts to the specified torque and
bend the tabs of the lock washer against the side
of each bolt.
TORQUE: 15-20 N.m (1.5-2.0 kg-m,
11-14 ft-lb)
Install the pin bolt caps.
BRAKE DISC INSPECTION
Measure the brake disc thickness.
SERVICE LIMIT: 3.0 mm (0.12
in)
Measure the brake disc warpage.
SERVICE LIMIT: 0.3 mm (0.01
in)
12-5
(4) PADS
(5) PAD SPRING
�HONDA
� MBXSO, MBXSO
(3) PIN BOOTS
(6) CALIPER
BRACKET
Summary of Contents for MBX50
