�HONDA
� MBXSO· MBXSO
Drive in the bearings with the following common
and special tools.
Balancer weight left bearing:
e Driver A
e Attachment 32 x 35 mm
e Pilot 12 mm
Mainshaft right and countershaft left bearings:
• Driver A
e Attachment 42 x 47 mm
• Pilot 17 mm
Mainshaft left bearing:
• Driver A
• Attachment 28 x 30 mm (07746-1870100)
CRANKSHAFT REMOVAL
Remove the crankshaft from the right crankcase.
Drive the crankshaft out of the right crankcase
if it is difficult to remove by hands.
NOTE
.. Use a plastic or brass hammer.
• Screw a nut onto the crankshaft end to
prevent damage.
• Protect the crankcase mating surface by
resting it on a wooden block.
CRANKSHAFT /TRANSMISSION
(1) CRANKSHAFT
9-8
Summary of Contents for MBX50
